![]() Even with the 15 minute wait that causes them to ignore HomeKit setup and theoretically only sets them up with WEMO app, with 5 GHz off and Legacy on, and so far I have not been able to set them up. ![]() Now my latest and biggest problem is that I bought the latest outlets (the small ones) and I have not been able to set them up. Occasional hiccups when there are software updates for HomeBridge that require updates for some Plugins, but overall far more reliable than the WEMO Bridge. Works well including for my Insteon, Kevo, Nest Protect and Ring devices that don’t currently support HomeKit. cycling power), so I switched to HomeBridge using a Raspberry Pi that I happened to have lying around. My HomeKit setup used to be with the WEMO Bridge, but that required resetting roughly weekly (I.e. Second generation outlet WeMo_WW_5.PVT-OWRT-SNSV2 (working)įirst generation wall switches WeMo_WW_1.PVT-OWRT-LS (two working, one not)įirst generation outlet WeMo_WW_1.PVT-OWRT-SNS (one working, two not) I’m puzzled by the firmware numbers shown above, as mine look quite different: If I closed off the 5 GHz channel on the EERO, and re-scanned the WEMO app they would reappear, but a short while later when the 5 GHz channel resumed these devices would go AWOL again. Tonight 3 of my devices went AWOL (a switch and two plugs - all first generation). Then I did the update to EERO 6.5.1 and that seemed to fix the problem, but I was wrong. Twice now in the last month or so most of my existing WEMO devices disappeared (usual “not detected” message in WEMO app, and HomeKit indicating no response). I have been having multiple problems with WEMO devices. it really makes me think it has to do with the Eero configuration (?) Since the other four (2 + 2 replacement) switches show signal and work when I connect to their own network. The weirdest thing is that the first plug is still working perfectly and I’m happy with it. Not my main network where the first switch was succesfully added. Sometimes it looks like it, when I, after a long wait can add them but then it adds it to the network of the plug itself. I have tried installing the devices both via the Homekit app and the Eero app multiple times. Now these replacements are also not being added to Homekit. Then I called Wemo Customer Support and they had no other options left for me and sent me two replacemenf switches. I did not get these two new switches to work. Went through the whole process as described by disabled all labs features, soft reset the main eero, turned off 5ghz, reset the Wemo plug, reset the router, move them closer to the router, try install with different iOS device, turn off cellular, turn off band steering. ![]() That’s when I decided to purchase another two of them. I did not do anything different I recall. I have my first Wemo Smart Plug installed and it works fine after just 2-3 attempts. Hello, I am experiencing the exact same problems. ![]()
0 Comments
Leave a Reply. |